Product Description & Reviews
INTRODUCTION The Arduino DMX shield is an add-on (or "shield") for the Arduino. It is an easy way to use the Arduino as a DMX-Master device, just by adding the DMX-shield on the top of the Arduino. The following settings are configurable via the onboard jumpers: Send data via TX or Digital pin 4 Receive data via RX or Digital pin 3 Hardware slave mode or Software Controlled Slave/Master via Digital pin 2 (Required for RDM) Enable / Disable shield In case you have the shield configured to use the RX and TX pins you have to disable the shield before you can upload your new sketch onto the Arduino board. This jumper allows you to disable the shield without disconnecting it from the Arduino board which saves time. SPECIFICATION Remote Device Management DMX Master DMX Slave SHIPPING LIST DMX shield x1
Features & Highlights
- This arduino DMX / RDM Shield is a low cost high quality solution that allows you to connect your Arduino driven artwork into DMX512 networks.
- The shield is populated with high quality NEUTRIK XLR 3pin Connectors (1x male and 1x female).
- The MAX485 based shield can be used as DMX Master, Slave and as RDM transponder.
- A unique RDM device id will be handed out from out range to you as well, this will make your device worldwide unique.
Additional Information
Manufacturer: | DFROBOT |
Brand: | DFROBOT |
Part Number: | 4328458204 |
Publisher: | DFROBOT |
Studio: | DFROBOT |
MPN: | 4328458204 |
UPC: | 605757689944 |
EAN: | 0605757689944 |
Item Weight: | 0.1 pounds |
Item Size: | 3.4 x 1.6 x 1.6 inches |
Have questions about this item, or would like to inquire about a custom or bulk order?
If you have any questions about this product, contact us by completing and submitting the form below. If you are looking for a specif part number, please include it with your message.